![]() ![]() I checked my status report and it seems to me that… Read more…Ĭalibration of RTK parameters using SRTC tool from PCSWMM When I changed this and runt, my model again, the continuity error went from ~ 3% to 7%. Up to hear nothing is out of extraordinary, however, at first, I set the outlet offset of the upstream pipes to the pumping stations to 0 m as no information was known in advance.My new model, same conditions as above, includes the offset of the upstream pipes for each pumping station. I have likewise set up the calibration for wet conditions and results are fair enough for both cases. I am working with PCSWMM (I apologize as I am not using SWMM per se) to set up my DWFs and flow patterns, run and calibrate the model (I have 7 points for calibration purposes). The system is roughly composed of 100 km of pipes, 13 lifting pump stations (34 pumps) and 1,600 junctions. Thank you all in advance!I am currently working at simulating the complete sewer system of a municipality. Hi all,I am reaching out hoping someone can enlighten me with two questions. Continuity error related to pumping and inclusion of on-site pumping measurements to simulations
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |